Stone Computers Knowledgebase

How to Update the BIOS on the Stone NT210-H Laptop

Article ID: 539
Last updated: 04 Mar, 2016
Article ID: 539
Last updated: 04 Mar, 2016
Revision: 6
Views: 709
Posted: 04 Mar, 2016
by Andrew Sharrad
Updated: 04 Mar, 2016
by Andrew Sharrad

How to Update the BIOS on the NT210-H Laptop

BIOS Updates are available for the Stone NT210-H Haswell based laptop.

Note: Please only update the BIOS if necessary. The BIOS should not be updated unless you are experiencing a specific issue which requires an update. This BIOS update is designed to be used by Administrators. Contact Stone Support for further advice.

What you need to Perform the Update

Steps

  • Extract the downloaded file to the pen drive.
  • Ensure that the system to be updated is connected to the AC mains and also has a battery level of at least 20%.
  • Boot the system to be updated from the pen drive.
  • Run ECFLASH to update the EC Firmware.
  • Then shut the system down if it doesn't turn off automatically.
  • Boot the system up again and start it again from the pen drive.
  • Run the FLASH batch file to flash the main BIOS.

Note 1: Do not attempt to use this BIOS update procedure inside a "DOS" box or command prompt inside another operating system. Always run all parts of the update from a pure DOS boot.

Note 2: Always ensure that the laptop is connected to the mains and that the battery has at least 20% charge before attempting to perform the flash.

Applies to:

  • Stone NT210-H Laptop - NOTCHA-272

This article was:  
Article ID: 539
Last updated: 04 Mar, 2016
Revision: 6
Views: 709
Posted: 04 Mar, 2016 by Andrew Sharrad
Updated: 04 Mar, 2016 by Andrew Sharrad
Also read