Stone Computers Knowledgebase

How to change the DMI information on a N120, NT210-H, NT308, NT309, NT310 or NT310-H Notebook

Article ID: 221
Last updated: 16 Oct, 2016
Article ID: 221
Last updated: 16 Oct, 2016
Revision: 7
Views: 2411
Posted: 15 Nov, 2013
by Andrew Sharrad
Updated: 16 Oct, 2016
by Andrew Sharrad

Changing DMI Strings

Some of the DMI strings in the Intel desktop board BIOSes can be changed using the utilty attached to this article. To run the utility, you will need a Windows 98SE bootable USB pen drive.

  1. Make the USB pen drive command prompt bootable.
  2. Disable UEFI boot in the BIOS, if enabled.
  3. Extract the utility to the pen drive.
  4. Boot the system from the pen drive (use the F10 option to get the boot menu).
  5. Run DMI.BAT

The following strings will be prompted for:

  • System serial number (this should be the serial number on the Stone serial number sticker).
  • Bay Number (normally this is not used; Stone systems may have a QC tracking number here).
  • Chassis Asset Tag (this should be used for the end-customer asset tag number).

​This DMI utility will also program "OEGStone" into the BIOS as a manufacturer string.

And lastly:

  1. Start the system back up and re-enable UEFI boot in the BIOS if it was previously enabled.

Applies to:

  • Stone / Clevo notebook models N120, NT210-H, NT308, NT309, NT310 and NT310-H

This article was:  
Article ID: 221
Last updated: 16 Oct, 2016
Revision: 7
Views: 2411
Posted: 15 Nov, 2013 by Andrew Sharrad
Updated: 16 Oct, 2016 by Andrew Sharrad
Attached files

Also read